Howto Configure CoovaChilli Listening On Multiple Interfaces

Creat a VLAN interface using ifcfg-vlan filename with following content. The value of IPADDR and NETWORK must be reflect your current VLAN setup.

DEVICE=vlan 
IPADDR=192.168.100.1 
NETWORK=192.168.100.0 
NETMASK=255.255.255.0 
USERCTL=no 
BOOTPROTO=none 
ONBOOT=yes

Edit the physical ethernet file, the eth0 were use as example and this value must reflect your current setting accordingly.

DEVICE=eth0
USERCTL=no
ONBOOT=yes 
MASTER=vlan 
SLAVE=yes 
BOOTPROTO=none

Following line must be add to modprobe.conf file to enable the VLAN device probing by the Linux OS.

alias vlan bonding options vlan mode=3 miimon=100

Change to below value in Chilli config file to fully enable the VLAN networking.

HS_LANIF=vlan